Make A Cardboard Roll Bracelet Or Cuff With A Kitchen Roll, Some Paint And A Handful Of Craft Gems And Jewels.
Then measure on the cardboard an eighth of an inch narrower and make your cut there. Cut a piece of soft cardboard with these measurements, which will act as structure for your cuff. I kept ultra suede a bit larger on sides since i formed my cuff with hands, therefore i could comfortably cut the right size after the glue dried.
Simply Wrap The Duct Tape Around Your Cardboard Tube Two Or Three Times To Make It Nice And Sturdy.
We used about half a roll, per the picture below. Add to favorites more colors dresden cardboard ornament / candle cuffs set of 10. Then, use your ribbon scraps to.
Then I Snipped Through The Roll To Separate The Bracelets.
Once it's dried cut around the circle again. Width is entirely up to you. Pour puddle of glue on wax paper.
Draw 4 Lines Across Your Disc To Create 8 Equal Segments.
This will be the length of your cuff. The roll was from a big roll of holiday wrapping paper. Take your seven strands of yarn and tie a knot at one end.
We’ll Call This The Base Cloth.
These two marks will be for our snaps. The width of your cuff, the whole tube might be too long, so cut it to the length that suits your wrist. Check out our cardboard bracelet selection for the very best in unique or custom, handmade pieces from our beaded bracelets shops.
