Some Say Just Put Some Water On It And Leave It, Others Say Scolding Hot Water And A Blow Drier With Hot Air.
Use a spray bottle of water just use a little water. So to avoid this problem, i soak the bracelets for a few secs in cold water just to get them wet then i dry them with a temp controlled heat gun set to 250 deg f. Make sure you check for sizing as you go, you don't want it to shrink too small.
You Can Also Blow Dry On The Lowest Heat Setting Possible.
Bomber & company firestarter paracord bracelet. You may have to repeat if it does not shrink enough. I used the boiling water to shrink a multicolored bracelet but the dyes on the paracord used ran in boiling water and ruined the entire bracelet.
Then Dry In The Sun.
If you're using a spray bottle, lay the leather item flat, then completely soak the entire surface. You can also blow dry on the lowest. The cold water causes the item to shrink.
Bracelets Are Kinda Like My Tattoos.
Below is a listing of the most frequently asked questions. If you need to, turn it over and soak the other side, as well. 28th february 2021 ♥ 0.
At First, Try Using Tap Water.
The process for shrinking paracord is really straightforward. I don't want to damage the leather : The high heat will force the rubber to shrink if you allow it to boil for 5 to 10 minutes.