Next, Fold A Piece Of Tape Over The End Of The Elastic To Prevent The Beads From Falling Off.
42767 | number of pages: The following part is also the same as the first knot, except now you have four strands. This leather wrap bracelet tutorial will teach you how to use two hole tila beads to make a beaded leather wrap bracelet with a button.
Put The Bracelet Around Your Wrist And Mark The Place Where The Strand Without Bead Is At Height Of The Beginning Of The Macrame.
Snug the two beads up close to one another and adjust the cord loops as needed to pull tight. Take one of the pieces of yarn you cut off in last step. Fold your leather in half and string on your button, placing it in the center of the leather.
This Step Is Optional If You're Using Beads With Very Large Holes;
Make the rest of the bracelets using a 2mm leather cord. Preparing the cord and beading. Form a loop around the finger tip.
1 Strand Of 6Mm Firepolish Or Druk Beads.
Thread the leather cord through the brass button, and move it down to the halfway point on the cord. Wrap over from right to left, and under from left to right. In that case, you can often string them directly onto the cord.
Finish With The Thread On The Left Side.
Use your fingers to hold the bead in place while you pull the thread taut. As the needle pops out the left side of the bead, thread it underneath the left leather cord before pulling it through. Now make another knot with both leather laces and the thread and pull tight.
